BMW 05 3 Bedienungshandbuch PDF herunterladen (Seite 94)

Controls

Reference At a glanceDriving tipsCommunications NavigationEntertainmentMobility

Practical interior accessories

Integrated universal remote

control*

The concept

The integrated universal remote control can

replace as many as three hand-held transmit-

ters for various remote-controlled devices,

such as door openers and house alarm sys-

tems. The integrated universal remote control

registers and stores signals from the original

hand-held transmitters.

The signal of an original hand-held transmitter

can be programmed on one of the three mem-

ory buttons 1. After this, the programmed

memory button 1 will operate the system in

question. The LED 2 flashes to confirm trans-

mission of the signal.

Should you sell your vehicle one day, be sure to

delete the stored programs beforehand for your

safety, refer to page 94.

To prevent possible damage or injury,

before programming or using the inte-

grated universal remote control, always inspect

the immediate area to make certain that no peo-

ple, animals or objects are within the pivoting or

travel range of the device being operated. Com-

ply also with the safety instructions supplied

with the original hand-held transmitter.<

Checking compatibility

If this symbol appears on the package

or in the instructions supplied with the

original hand-held transmitter, you can

assume that the radio remote control device will

be compatible with the integrated universal

remote control.

If you have additional questions, please

consult your BMW center or call 1-800-

355-3515.

You can also visit these websites:

www.bmwusa.com or

www.homelink.com.

HomeLink is a registered trademark owned by

Johnson Controls, Inc.<

Programming

1 Memory buttons

2 LED

Fixed-code hand-held transmitters

1. Switch on the ignition, refer to page 49.

2. When starting operation for the first time:

Press both outer memory buttons 1 for

approx. 20 seconds until the LED 2 flashes.

All stored programs are cleared.

3. Hold the original hand-held transmitter at a

distance of approx. 2 to 8 in/5 to 20 cm from

the memory buttons 1.

The required distance between the

hand-held transmitter and the mem-

ory buttons 1 depends on the system of the

respective original hand-held transmitter

used.<

4. Simultaneously press the transmit key on

the original hand-held transmitter and the

desired memory button 1 on the integrated

universal remote control. The LED 2 flashes

slowly at first. As soon as the LED 2 flashes

rapidly, release both buttons. If the LED 2

does not flash rapidly after approx. 15 sec-

onds, alter the distance.

5. To program other original hand-held trans-

mitters, repeat steps 3 and 4.

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 222 223

BMW 05 3 Bedienungshandbuch Seite 94

Kommentare zu diesen Handbüchern

BMW 05 3 Bedienungshandbuch Seite 94

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Telefone BMW 05 3