BMW R1100 Spezifikationen PDF herunterladen (Seite 45)

Oil Change - Paul Glaves

1. Warm up engine thoroughly

2. Turn off engine

3. Place motorcycle on center stand

4. Place drain pan under the drain plug in the bottom of the oil pan

5. Remove oil filler plug to let air into crankcase

6. Take 8mm allen wrench and carefully remove the plug without burning

yourself

7. Let oil all drain into the drain pan.

8. Take 3/8 drive ratchet with short extension and BMW filter wrench in hand.

9. Locate the oil filter in the recess in the oil pan casting

10. Remove the oil filter

11. Fill the new oil filter with fresh engine oil.

12. Oil the oil filter rubber gasket ring which contacts the machines block

surface

13. Install the oil filter until finger tight plus 1/4 turn or torque to 8 ft. lb. (11 Nm)

14. Re-install the drain plug with a NEW crush washer - snug but not gorilla

tight or torque to 23 ft.lb. (32 Nm)

15. Add the remaining amount of the specified quantity of the specified viscosity

oil to the crankcase (~3.75 quarts)

16. Re-install the oil filler cap

17. Start engine

18. Turn off engine

19. Wait several hours and check the oil level in the sight glass. The level must

be above the bottom of the ring. On the dot is as specified, and must not be

above the top of the ring.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 63 64

Keine Kommentare

BMW R1100 Spezifikationen Seite 45