BMW Z4 3.0i Bedienungshandbuch PDF herunterladen (Seite 90)

Replacement procedures

88

Replacement procedures

Onboard tool kit

The onboard tool kit is stored in a tool

pouch. It is located in the luggage compart-

ment beneath the floor panel.

Windshield wiper blades

1. Fold the wiper arm completely out from

the windshield

2. Position the wiper blade at an angle and

pull the release spring, see arrow

3. Fold the wiper blade down and unhook

it toward the windshield

4. Pull the wiper blade past the wiper arm

toward the top

5. Insert a new wiper blade and apply

pressure until you hear it engage.

Lamps and bulbs

The lamps and bulbs make essential contri-

butions to the safety of your vehicle. There-

fore, comply fully with the following instruc-

tions during bulb replacement. If you are

not familiar with the procedures, BMW rec-

ommends that you have your BMW center

carry out the work.

Do not touch the glass portion of

a new bulb with your bare hands

since even small amounts of impurities

burn in to the surface and reduce the ser-

vice life of the bulb. Use a clean cloth,

paper napkin or a similar material, or hold

the bulb by its metallic base.<

A replacement bulb set is available from

your BMW center.

Before working on the electrical sys-

tem, switch off the electrical acces-

sory you are working on or disconnect the

cable from the negative terminal of the bat-

tery. Failure to observe this precaution

could result in short circuits.

To prevent injuries and damage, always

comply with any instructions provided by

the bulb manufacturer.<

Accessing the headlamps

Protective cover in the wheel well

To gain access to the headlamp covers,

turn the front wheels in the required direc-

tion.

Online Version for Part No. 01 41 0 157 498 - © 10/03 BMW AG

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 119 120

Kommentare zu diesen Handbüchern

Keine Kommentare