BMW HP4 Wartungshandbuch PDF herunterladen (Seite 97)

Press and hold button 2, until

the value next to "REB:" re-

spectively "COM:" is flashing.

Adjust damping as desired us-

ing buttons 1 and 2.

+1 .. +7: Damping increase in

maximum seven steps.

-1 .. -7: Damping decrease in

maximum seven steps.

0: Basic setting.

Performing zero position

alignment

Place the motorcycle on the

side stand or a suitable auxiliary

stand.

During the alignment, do not sit

on the motorcycle and remove

any cargo or luggage.

In order to adjust the zero po-

sition, press buttons 1 respec-

tively 2, until position 3 shows

"DDC" and position 4 shows

"CAL" (calibration).

Next, press and hold button 2,

until lettering "CAL" starts

flashing.

If zero position adjustment was

successful, a check mark is

shown.

If the check mark is not shown:

Repeat alignment.

If the check mark is not shown

after repeated alignment at-

tempts, consult a specialized

workshop, preferably an autho-

rized BMW Motorrad retailer.

Installing plug connector

for a leveling sensor

Removing fairing side panel

( 129).

On the racetrack

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 193 194

Keine Kommentare

BMW HP4 Wartungshandbuch Seite 97