Bmw 760Li Sedan 2010 Bedienungsanleitung PDF herunterladen (Seite 134)

To do so:

▷ Read the instructions of the hand-held

transmitter.

▷ Press the memory button of the universal

remote control for an extended period.

If the LED flashes rapidly for a brief period and

then lights up continuously for approx. 2 sec‐

onds, the hand-held transmitter is equipped

with an alternating code system.

In this case, program the memory buttons as

described under Alternating-code hand-held

transmitter.

Alternating-code hand-held

transmitters

Please obtain information on synchronizing the

device in the operating manual of the device be‐

ing set up.

Programming will be easier with the aid of a sec‐

ond person.

1.

Park the vehicle within range of the remote-

controlled device.

2. Program the universal remote control as de‐

scribed above under Fixed-code hand-held

transmitters.

3. Press and hold the programmed button on

the interior rearview mirror for approx. 5 sec‐

onds until the device to be adjusted is acti‐

vated.

If the device does not become activated,

press and hold the button and watch the

LED:

▷ If the LED lights up continuously, the

programming is completed. The device

should become activated when the but‐

ton is pressed briefly.

▷ If the LED flashes for approx. 2 seconds

and then lights up continuously, con‐

tinue the programming procedure be‐

ginning with step 4.

4. Locate the button on the receiver of the de‐

vice to be set, e.g., on the drive.

5. Press the button on the receiver of the de‐

vice to be set. You have approx. 30 seconds

for the next step.

6. Press the programmed memory button of

the universal remote control three times.

The device can be operated when the engine is

running or the ignition is switched on.

Reassigning individual programs

1. Switch on the ignition.

2. Hold the hand-held transmitter at a distance

of approx. 2 to 8 in/5 to 20 cm from the mem‐

ory buttons.

3. Press the memory button of the universal

remote control.

4. If the LED flashes slowly after approx.

20 seconds, press the transmit button on

the hand-held transmitter.

5. Release both buttons when the LED flashes

rapidly.

If the LED does not flash rapidly after approx.

15 seconds, change the distance and repeat

the step.

Deleting all stored programs

Press the left and right memory buttons for ap‐

prox. 20 seconds until the LED flashes rapidly.

All stored programs are deleted.

The programs cannot be deleted individually.

Seite 134

134

Online Edition for Part no. 01 41 2 602 638 - © 09 09 510 BMW AG

Interior equipment

1 2 ... 129 130 131 132 133 134 135 136 137 138 139 ... 279 280

Kommentare zu diesen Handbüchern

Keine Kommentare