BMW 3 1993 Bedienungsanleitung Seite 27

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 32
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 26
107 False code set
110 EGS control unit not programmed Have EGS control unit programmed
105 DKT throttle valve signal 35
Break in wiring short in wiring
Anomalous throttle valve signal
106 MUX injection rate DDE sending faulty injection rate signal
110 EGS control unit not programmed Have EGS control unit programmed
(150) Can timeout 1 Can signal not sent during engine start (ignition
on)
(151) Can timeout 2 Can signal not detected (engine running)
(152) Can bus monitor Values in can ram storage not updated
(153) Can status fault Control units with different can status' are
installed on the same bus
Replace with correct units
(154) Can throttle valve signal Anomalous throttle valve signal detected by
DME
(155) Can load signal Anomalous load signal detected by DME
(156) Can engine intervention DME cannot alter engine torque to match EGS
signal
DME does not match other can control units
(157) Can engine temperature Anomalous engine temperature signal detected
by DME
(158) Can engine speed signal Anomalous engine speed signal detected by
DME
200 Kickdown not working
201 Sport car transmission feature not selectable
202 Manual shift program feature not selectable
203 Program cannot be converted 6
204 No engine deceleration detected 24
205
Brake light
Brake light test switch
206 False code set
300 Diagnostic circuit fault
301 EGS voltage supply
No voltage to EGS control unit
Check wiring harness
A5S 310Z (5HP-18) - EGS 7.XX
CODE DEFINITION OF FAULT
EGS
PIN OUT
POSSIBLE CAUSES
02 Solenoid Parking/Neutral lock 2
Break in wiring
Short in wiring
Defective valve winding
03 Solenoid valve 5
Break in wiring
Short in wiring
Defective valve winding
27 of 32 11/15/00 9:55 AM
bmwcodes http://www.baumtools.com/bmwcodes.htm
Seitenansicht 26
1 2 ... 22 23 24 25 26 27 28 29 30 31 32

Kommentare zu diesen Handbüchern

Keine Kommentare