BMW 3 1993 Bedienungsanleitung PDF herunterladen (Seite 16)

Please check the wire resistance. If necessary replace the cable set.

5 SEAT BELT TENSIONER SUPPLY WIRE RESISTANCE TOO HIGH -

Please check the wire resistance. If necessary replace the cable set.

6 SEAT BELT TENSIONER SUPPLY WIRE - POWER SUPPLY DEFECT -

Check the sensor wire for breaks or shorts. Check the connectors for

corrosion and breakage.

7 CRASH SENSOR TRIGGERED - FRONT LEFT - Check the sensor,

wires and connections for breaks, shorts or defects Delete faults in

memory, drive vehicle over 15 mph, then rerun diagnosis.

8 CRASH SENSOR FAULT - FRONT LEFT - Check the sensor, wires and

connections for breaks, shorts or defects Delete faults in memory, drive

vehicle over 15 mph, then rerun diagnosis. Replace the Crash Sensor if

the fault recurs.

9 CRASH SENSOR GROUND CONTACT FAULT - FRONT LEFT - Check

the sensor ground contact. Check the battery ground contacts. Delete

faults in memory, drive vehicle over 15 mph, then rerun diagnosis.

Replace the Crash Sensor if the fault recurs.

10 CRASH SENSOR TRIGGERED - FRONT RIGHT - Check the sensor,

wires and connections for breaks, shorts or defects. Delete faults in

memory, drive vehicle over 15 mph, then rerun diagnosis.

11 CRASH SENSOR FAULT - FRONT RIGHT - Check the sensor, wires and

connections for breaks, shorts or defects. Delete faults in memory, drive

vehicle over 15 mph, then rerun diagnosis. Replace the Crash Sensor if

the fault recurs.

12 CRASH SENSOR GROUND CONTACT FAULT - FRONT RIGHT - Check

the sensor ground contact. Check the battery ground contacts. Delete

faults in memory, drive vehicle over 15 mph, then rerun diagnosis.

Replace the Crash Sensor if the fault recurs.

13 CRASH SENSOR SUPPLY RESISTANCE TOO HIGH - FRONT LEFT -

Check the sensor, wires and connections for breaks, shorts or defects.

Delete faults in memory, drive vehicle over 15 mph, then rerun diagnosis.

14 CRASH SENSOR SUPPLY WIRE FAULT - FRONT LEFT - Check the

sensor, wires and connections for breaks, shorts or defects Delete faults

in memory, drive vehicle over 15 mph, then rerun diagnosis.

15 CRASH SENSOR SUPPLY RESISTANCE TOO HIGH - FRONT RIGHT -

Check the sensor, wires and connections for breaks, shorts or defects.

Delete faults in memory, drive vehicle over 15 mph, then rerun diagnosis.

16 CRASH SENSOR SUPPLY WIRE FAULT - FRONT LEFT - Check the

sensor, wires and connections for breaks, shorts or defects Delete faults

in memory, drive vehicle over 15 mph, then rerun diagnosis.

17 WARNING LAMP SHORT CIRCUIT - A short-circuit exists in the

instrument panel or in the supple wire from the control unit to the

instrument panel. Please check whether the SRS warning light either

lights up permanently or not at all.

18 WARNING LAMP DEFECT - Please check the airbag signal bulb in the

instrument panel and replace it if necessary.

19 CRASH DETECTION ACCUMULATOR ACTIVATED - The detection

accumulator is activated by the operation of the SRS system.

* ATTENTION! THIS ACCUMULATOR CAN ONLY BE DIAGNOSED AND

RESET BY THE BMW DEALER.

20 SRS CONTROL UNIT DEFECT - DEALER REPLACEMENT ONLY

-Delete fault stored in memory. Operate vehicle for 5 minutes. If the fault

re-occurs, the SRS Control Unit will need replacement.

16 of 32 11/15/00 9:55 AM

bmwcodes http://www.baumtools.com/bmwcodes.htm

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 31 32

Kommentare zu diesen Handbüchern

Keine Kommentare

BMW 3 1993 Bedienungsanleitung Seite 16

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Autos BMW 3 1993