Encoding the remote controls
Note: All RF remote controls must be
encoded at the same time for them to be
functional
• Press and hold buttons A and B on the
remote control simultaneously.
• LED on remote will flash rapidly, keep
buttons A and B pressed down.
• After approximately 10 seconds, the
remote LED will stop flashing, release
buttons A and B.
• Once released, the RF Remote LED will light up steadily.
• Press either button A or B.
• A beep will indicate that the encoding of the remote control has been suc-
cessful.
• Repeat the procedure for all other remote controls.
125
R 1200 CL
Alarm System Programming Information
R 1200 CL Introduction
RF Remote LED
Encoding RF Remote Control
Kommentare zu diesen Handbüchern