9 Use of the rear seats
Never wear the SCHROTH harnessbelt if any rear seating
position is occupied. Both front seat occupants must then
use original equipment 3-
point belts. The rear seat occupant
could interact with the tail strap of the SCHROTH
harnessbelt during an accident and cause serious injury to
himself or to the wearer of the harness belt.
right way wrong way right way
• As a constant reminder, the enclosed transparent sticker
must be attached to the rear side window in a prominent
place. The sticker cannot be removed without damage to
chromate tinted glass. On such vehicles, you may affix
the transparent sticker at a different, prominent location
so that it will serve as a constant reminder.
10 Stowing the belts when not in use
If you use the stock 3-point belt instead of the SCHROTH
harnessbelt, be sure to properly stow the SCHROTH harness
belt so that it is not exposed to seat tracks, liquids, sun light,
or any other area where the belt could possibly be damaged.
When not in use we recommend that you unhook all four
points are remove the entire belt for proper storage.
Page 19
CARE and MAINTENANCE
1 Inspection
Check the safety belt once a month for any damage. Cuts,
tears and other damage to the belt will greatly reduce its
effectiveness. Replace the belt or damaged parts immediately
with original Spare Parts (see page 37, Spare Parts). Never
use a damaged harness belt, use the standard 3-point belts
which remain available for use.
Make sure the buckles are free of any obstruction and lock
securely.
Modified belts or such belts that have been resewn are not
strong enough and are dangerous in an accident.
Never modify, disassemble or repair the belts yourself.
For parts that can be replaced, use only original SCHROTH
Spare Parts.
Only original SCHROTH Accessories may be used with the
harness belt system.
Use of non-authorized parts and Accessories can reduce
the effectiveness of the harness belt system.
Figure A:
Fold the strap to a loop and insert it
upwards throughout the metal frame and
turn the loop as indicated.
Note:
The strap part protruding from the adjuster
for further adjustment
above the stress taking strap [2].
Figure B:
Position the plastic cover on top of the
loop and insert the metal retainer
[3]
through the guides of the plastic cover
and the strap loop.
Figure C:
Keep the metal
retainer positioned
between your thumb and forefinger. Slide
the plastic cover backwards onto the
metal frame as indicated until both
ratchets
[4] locks with a distinct clicking
sound into the detentions in the metal
frame.
Figure D:
Check by pull
straps
[2] and [2`] the adjustment device
will lock safely.
(189 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern