BMW E36 Convertible Betriebsanleitung PDF herunterladen (Seite 10)

SCHROTH bracket so that the webbing is following

the desired path once the lap belt is connected.

q Torque the bolt to 30 ft.lbs.

Page 9

3.4 Outside lap belt mounting point s – E36 Sedan

q Unbolt the seat from the floor mounts. Move the seat

all the way back and remove the front floor mounting

nuts using a 16mm socket. Move the seat all the way

forward and remove the rear mounting bolts.

q DO NOT REMOVE

THE SEAT. Tip the

seat in toward the

front of the car to

expose the BMW

anchor bolt at the

rear side of the

seat-mount

bracket.

q Use a razor blade

to trim back the

plastic as shown in the picture above to allow space

for the SCHROTH Lap Belt Tail Strap.

q Using a T50 Torx socket remove the bolt that holds

the factory lap belt in place.

q Place the SCHROTH mounting bracket directly

beneath the bolt head and reinstall the BMW factory

anchor bolt. Torque to 30 ft.lbs.

q Reposition the seat over its mounting point and

remount the two front retaining nuts and two rear

retaining bolts.

4 Installation of the tail strap connectors

4.1 Tail strap connectors- Left (Drivers Side) Belt

All E36 models

No installation is required. Simply plug the male

ends of the SCHROTH harness tail strap into the left

most rear seat and the center mounted rear seat

BMW factory female receptacles.

4.2 Tail strap connectors- Right (Passenger Side) Belt

All E36 models

q Remove rear seat cushion by lifting up firmly on the

front edge of the cushion about 8” in from either

side.

q Using a 16mm hex

socket, remove the

anchor bolt holding the

rear passenger side lap

belt.

q Using two pair of pliers,

carefully bend the

SCHROTH bracket so

that it fits as shown in the

picture to the right.

q Reinstall the BMW factory anchor bolt placing the

SCHROTH bracket directly under the bold head and

positioned as shown in the picture above.

q Reinstall the rear seat cushion being sure that the

SCHROTH tail strap connector is positioned above

the top of the seat cushion.

4.3 Tail strap connectors – Left & Right Belts

All E39 models

q No installation is required for the inboard mounting

points of the tail straps. Simply plug the male ends

of each SCHROTH inboard tail strap to their

respective BMW factory female receptacles in the

center of the rear seat.

q Outer most mounting points require installation of a

SCHROTH Tail Strap Connector. Lift out the rear

seat cushion by lifting up firmly on the front edge of

the cushion 8” in from either side and in the middle.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 21 22

Kommentare zu diesen Handbüchern

Keine Kommentare

BMW E36 Convertible Betriebsanleitung Seite 10

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Autos BMW E36 Convertible