Bmw 330XI Bedienungsanleitung PDF herunterladen (Seite 128)

128

Coolant

Do not add coolant to the cooling

system when the engine is hot. If

you attempt to do so, escaping coolant

can cause burns.

Antifreeze and anti-corrosion agents

are hazardous to health. You should

always store them in original containers

and in a location which is out of reach

of children. Antifreeze and anti-corro-

sion agents are inflammable. For this

reason, do not spill them on hot engine

parts. They could ignite and cause seri-

ous burns. Comply with the instructions

on the containers.<

Checking the coolant level and

adding coolant

Check the coolant level when the

engine is cold, approx. 687/+206.

1. Open the cap for the expansion tank

by turning it slightly counterclock-

wise to allow accumulated pressure

to escape, then open

2. The coolant level is correct when the

upper end of the red float is at least

even with the upper edge of the filler

neck; see arrow. The end of the float

may stick out by a maximum of

3/4 in / 2 cm – that is, up to the sec-

ond mark on the float

3. If necessary, add coolant. If the cool-

ant is low, slowly add coolant until

the correct level is reached – do not

overfill.

Comply with the applicable envi-

ronmental laws regulating the dis-

posal of antifreeze agents with corro-

sion inhibitor.<

1 2 ... 123 124 125 126 127 128 129 130 131 132 133 ... 165 166

Keine Kommentare

Bmw 330XI Bedienungsanleitung Seite 128