BMW X5 DVD Video System II Bedienungsanleitung PDF herunterladen (Seite 7)

22. Locate 4 pre-marked holes on the mounting bracket. Remove

the bracket from the overhead console and drill 4 holes using a

1/8” drill bit.

23. Reposition the bracket on the overhead console and drill 4

pilot holes through the holes into the headliner. Insert a screw in

each hole to secure the bracket onto the overhead console.

You want to drill and screw one hole at a time, each time

making sure the bracket is aligned over the opening. Do not

drill all 4 holes at the same time.

Do not over-tighten the screws.

Picture of the dome light mounting bracket screwed in place.

24. Place the overhead console inside the vehicle and turn it

upside down (the monitor faces down toward the floor).

25. Bring the overhead console up to the headliner and position

its mounting location so that the mounting slots line up with the

mounting brackets.

26. Push on the edges of the overhead console and slide it

toward the rear of vehicle until the bracket seats in slot.

27. Locate the 2 pre-drilled holes in the overhead console near

the A/V unit and use a center punch or nail to punch through

those 2 holes into the headliner.

28. Flip down the monitor and locate the other 2 pre-drilled holes

and center punch or mark the locations into the aluminum cover

on the headliner.

29. Remove the overhead console from vehicle and confirm that

4 holes have been marked into the headliner.

At this point, close the sunroof shade fully before you drill

the holes.

30. Use the 1/8” drill bit, drill 4 pilot holes (2 into the headliner at

the back, and 2 into the aluminum cover by the monitor). Then

use the 5/16” drill bit supplied with the kit (with the stopper) to

enlarge the holes. Be very careful here as you only want to

enlarge the hole and not drill into the roof structure.

31. Insert the white nylon grommets into the 4 holes by pushing

up and snapping them in place.

1 2 3 4 5 6 7 8 9 10 11 12

Keine Kommentare

BMW X5 DVD Video System II Bedienungsanleitung Seite 7