BMW X5 DVD Video System II Bedienungsanleitung PDF herunterladen (Seite 8)

33. Use the supplied fish tape, fish the A/V and Power cables

from the overhead console opening in the headliner to the left

side of the vehicle.

When routing the cables, make sure they are routed away from

the left rear overhead airbag (for model year 03+).

34. Bring the overhead console inside the vehicle and locate the

console pass-through holes. The A/V, power, and left seatback

switch (if available) cables will go through the left hole. The

ultrasonic sensor, dome light, and right seatback switch (if

available) cables will go through the right hole.

35. Route the cables through the appropriate holes and leave

enough slack.

36. Raise the overhead console up to headliner and position it on

the mounting brackets. Push and slide the overhead console

rearward to mount it onto the headliner.

37. Insert 2 screws into the holes (drilled in step 30) by the A/V

unit and tighten them. Do not over tighten them.

38. Flip down the monitor and insert the other 2 screws into the

holes and tighten them onto the aluminum cover.

Here is a picture of the overhead console mounted onto the

headliner with the cables properly routed.

39. Plug the A/V cables (L/R audio, and Video) into AUX-1

connectors. Plug the power cable into the power connector

located on the opposite side of the AUX-1 connectors.

40. Reconnect the ultrasonic, dome light, and left and right

seatback switch (if available) cables.

41. Attach the overhead dome light console onto the bracket.

Make sure it seats tightly in the overhead console.

1 2 3 4 5 6 7 8 9 10 11 12

Keine Kommentare

BMW X5 DVD Video System II Bedienungsanleitung Seite 8