BMW AG/ICOM Bedienungsanleitung PDF herunterladen (Seite 121)

BMW Group

Page 121

Documentation/ISTA User's Manual of 132

New operation to be created and opened

Use this option if the current operation no longer has anything in common with the old (selected)

one either in technical or chronological terms. The workshop system copies the selected operation.

A new operations report will be created, however, and the original procedure data will not be used.

3.7.3 Simultaneous access to an ISTA operation

An operation cannot

simultaneously be processed by several service technicians. A complete copy

of the operation is created so that several service technicians can work on the same operation

simultaneously (Chapter 3.7.2.2).

3.7.4 Time-dependent status change

The time after the operations are removed from the operations list depends on the operation status.

The "New" and "In progress" statuses are automatically replaced after 7 days with the

"Terminated" status. The "Interrupted" status is set to the "Terminated" status after 14 days.

Terminated operations are only displayed in the operations list if a filter has been set

correspondingly. They can be reedited from this list. Operations with the "Terminated" status are

completely deleted from the operations list only after 14 days (exception: if there is a very large

number of operations and the reserved memory range on the ISIS is exhausted, then the oldest

operations with the "Terminated" status will be deleted before the 14-day period expires.

3.7.5 Workshop PC

The operation and its protocol data are always available on the workshop server. The PC is only

used in online mode.

3.7.6 ISID in offline mode

If you have to switch to the offline mode with the ISID, any open operation must first be interrupted

or terminated. This operation will then be transferred to the ISID when you change over to offline

operation. This operation is set to the "In progress" status on the ISIS and

therefore cannot be simultaneously edited by another user.

You can edit other vehicles in offline mode. In this case, the operations and the associated protocol

data are initially generated and saved locally on the ISID. When the device goes online again, it is

resynchronized with the workshop server.

3.7.7 TeleServices

As far as the user is concerned there is only one possible operation in the "TeleServices" mode.

The "Operations list" tab is not available. Operations are automatically created and terminated and

will be invisible from the user's point of view. It is not possible to pause. As is usual for all

procedures, logs are generated for the FBM.

V 1.0/2008-11-04

www.bmwicom.net

1 2 ... 116 117 118 119 120 121 122 123 124 125 126 ... 131 132

Keine Kommentare

BMW AG/ICOM Bedienungsanleitung Seite 121