BMW Z3(E36/7) Bedienungsanleitung PDF herunterladen (Seite 3)

EN/1-3

1. Important information

Specialist knowledge required.

The installation time is at least 4.0 hours, but may vary depending on the condition of the car and the equipment

in it.

Target group

The towing hitch installation kit may only be installed by a BMW dealership, which is the only place to have the

appropriately trained personnel with the necessary tools and equipment.

Safety instructions

BMW cannot accept any liability for damage caused by ignoring the work and the safety instructions set out in

this document. In addition, if the accessory is not installed and handled properly as set out in these installation

instructions, no claims under the guarantee will be accepted by BMW AG.

Electrical cables are to be installed in such a way that they cannot be damaged from kinking, chafing or

crushing.

Installation instructions

The installation work is shown for a LHD model. For an RHD model, the installation is to be completed the

opposite way round.

Keep to the tightening torque values for screw connections.The required tightening torque values are listed

in the parts information system (TIS).

If the specified PIN slots are already in use, bridges, double crimps or parallel end stops are to be used.

Under no circumstances should you use so-called "Scotchlock connectors" since they may cause faults in the

vehicle's electrical system.

The body sealant and underseal is to be removed from all body support areas for the towing hitch.The areas

must then be cleaned with benzene. Coat bare body areas with anti-corrosion paint.

The maximum trailer load is given in the car’s registration document.

The care and maintenance instructions are described in the instructions for use for the towing hitch.

Deburr the edges of all drilled holes and coat them with anti-corrosion paint. Remove all chippings.

An additional cover for the bumper is required to cover the cut-out in the bumper.This cover must be ordered

separately.

Screw union instructions

Position all bolts and nuts by hand and initially only tighten them by hand.

Align the towing hitch and holder for the ball head.

Tighten the bolts and nuts in the following sequence:

1. Collar nuts for the towing hitch / rear bulkhead

2. Hexagonal bolts, size M10, side supports / boot

Tools and equipment required

Screwdriver

Philips screwdriver

1/4 inch reversible ratchet

1/4 inch extension

1/4 inch socket, size 8 mm

1/2 inch reversible ratchet

1/2 inch extension

1/2 inch torque wrench

1/2 inch sockets, sizes TX 20,TX 22,TX 27 and TX 45

1/2 inch sockets, sizes 10 mm, 13 mm, 16 mm and 17 mm

Step drill, 40 mm

Anti-corrosion paint

Benzene

Marker pen (water-soluble)

Drill

Twist drills, sizes 4 mm, 8 mm and 14 mm

Open-ended spanners, sizes 12 mm and 13 mm

Bent ring spanner, size 16 mm

Primer pencil

Paint pencil

Hammer

Jigsaw

Tape measure

Centrepunch

Round file

Bradawl

1 2 3 4 5 6 7 8 ... 22 23

Kommentare zu diesen Handbüchern

Keine Kommentare

BMW Z3(E36/7) Bedienungsanleitung Seite 3

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Autos BMW Z3(E36/7)