BMW Z3(E36/7) Bedienungsanleitung PDF herunterladen (Seite 10)

2.4 Additional wiring harness installation

Fold out folded page 2-37

roadster only

Mark the boot floor (1) as shown in the illustration and drill a hole with a diameter of 33 mm for the additional

wiring harness.

Ensure that when you drill the hole, the bracket beneath for the exhaust system is not damaged.

Insert the additional wiring harness (a) through the hole (2) and fit the rubber grommet (3) into the hole (2).

The rubber grommet must sit securely in the hole to prevent the ingress of water. If necessary, seal it with

silicon.

coupé only

The hole (2) is to the side of the cable passage to the registration plate light.

Lay the additional wiring harness a along the vehicle wiring harness to the tail lights.

Connect branch A6, black 8-pin plug casing, to the black 8-pin socket casing X319 (4) on the left-hand tail light.

Connect branch A7, black 8-pin socket casing, to the tail light E46.

Connect branch A3, white 1-pin plug casing, to branch B2, white 1-pin socket casing, on additional wiring

harness b.

Connect branches A1 and A2 to the right-hand tail light in the same way as you connected A7 and A6 to the

left-hand tail light.

Lay additional wiring harness b along the vehicle wiring harness, on the right-hand side of the car, to the

installation site of the battery.

Cut branch B1, red cable, to the correct length. Crimp on a connection plug, insert it into the fuse holder C1

and secure it.

Connect branch C2 to the battery positive pole.

The illustration shows a car with the battery in the engine compartment. Proceed accordingly for cars with

a battery in the boot.

Connect branch A8, brown/white cable, and branch A9, brown cable, to the ground post X13015 (5) on the

left-hand side member.

Connect branch A5, 13-pin trailer plug X630, to the trailer socket casing (6).

Connect branch A4, green 2-pin socket casing, to the separate mounting of the trailer socket casing (6).

Secure the entire trailer socket to the towing hitch using the enclosed slot bolts (7) and self-locking nuts (8).

Ensure that the rubber cover (9) is fully over the edge of the trailer socket casing (6).

2-30/EN

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 22 23

Keine Kommentare

BMW Z3(E36/7) Bedienungsanleitung Seite 10