Bmw X5 3.0si SAV 2007 Bedienungsanleitung PDF herunterladen (Seite 48)

Adjusting

46

tional safety device, but they do not represent a

substitute.

n

Fastening

Make sure you hear the latch plate engage in

the belt buckle.

Safety belt reminder for driver's seat

and passenger seat

The indicator lamp lights up and a

signal sounds. A message also

appears on the Control Display.

Please check whether the safety belt is cor-

rectly fastened.

The safety belt reminder is operative at speeds

above approx. 5 mph/8 km/h. It can also be acti-

vated if objects are placed on the passenger

seat.

Releasing

1. Grasp the belt firmly.

2. Press the red button in the buckle.

3. Guide the belt into its reel.

The shoulder strap's anchorage point will be

correct for adult seat occupants of every build if

the seat is correctly adjusted, refer to page 41.

The two rear safety belt buckles integrated into

the rear seat are for passengers sitting on the

left and right. The belt buckle embossed with

the word CENTER is intended exclusively for

use by passengers riding in the center position.

Damage to safety belts

In the event of loads caused by accidents

or other damage: replace the belt system

including the safety belt tensioners and any

child restraint systems, and have the belt

anchor points checked. Only have this work

carried out at a BMW Sports Activity Vehicle

Center or at a workshop that works according to

BMW repair procedures with correspondingly

trained personnel. Otherwise correct operation

of this safety equipment is not guaranteed.<

Belt-force limiter

The effect of the belt-force limiter on the

driver's seat is dependent on the position of the

driver's seat.

To maintain the long-term accuracy of this

function, the driver's seat must be calibrated if a

corresponding message is displayed on the

Control Display.

Calibrating driver's seat

The warning lamp lights up. A mes-

sage also appears on the Control Dis-

play. Please calibrate the driver's

seat.

1. Move the driver's seat forward until it stops.

2. Move the driver's seat forward again. It

briefly moves toward the front in the pro-

cess.

3. Set the desired seating position again.

The calibration is completed when the message

on the Control Display disappears. Should this

message continue to be displayed, repeat the

calibration. If the message does not disappear

even after repeated calibration, have the sys-

tem checked as soon as possible.

Never carry out calibration while the vehi-

cle is moving, as otherwise accidents

could occur.

During the calibration, make sure that no per-

sons or objects are pinched, as otherwise inju-

ries or damage could occur.<

Online Edition for Part no. 01 41 0 012 501 - © 08/06 BMW AG

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 271 272

Kommentare zu diesen Handbüchern

Keine Kommentare