BMW 760i Bedienungshandbuch PDF herunterladen (Seite 207)

Mobility

205

Reference At a glanceControlsDriving tipsCommunications NavigationEntertainment

Grasp the handle in the upper panel and

fold it down.

Undo the wingnut and remove the jack.

After use, screw the jack all the way

back down and snap the handle back

into place.

Spare tire

1. Unscrew the wing nut 1

2. Remove the disc 2 to the side

3. Completely unscrew the threaded rod 3

4. Remove the spare tire.

Preparing wheel change

1. Read carefully and comply with the

safety precautions on page 204

2. Secure the vehicle to prevent it from

rolling:

Place the wheel chock against the rear

surface of the front tire on the side

opposite the side being raised. If the

vehicle is parked on a downward slope,

place the wheel chock securely in front

of the tire. On a steep grade, also

secure the vehicle against rolling

3. Loosen the lug bolts 1/2 a turn.

Lifting vehicle

1. Position the jack at the jacking point

closes to the wheel so that the entire

jack base makes contact vertically

under the jacking point

The vehicle jack is designed for

changing wheels only. Do not

attempt to raise another vehicle model

with it or to raise any load of any kind.

To do so could cause accidents and

personal injury.<

2. Guide the jack head into the rectangular

recess of the jacking point when crank-

ing up the jack, refer to section of illus-

tration

3. Jack the vehicle up until the wheel you

are changing is raised from the ground.

Mounting a wheel

1. Unscrew the lug bolts and remove the

wheel

2. Remove accumulations of mud or dirt

from the mounting surfaces of the

wheel and hub. Clean the lug bolts

3. Position the wheel or spare tire on the

hub and screw in at least two bolts

diagonally.

When you mount wheels other than

Genuine BMW light-alloy wheels, differ-

ent lug bolts may also be required

4. Screw in the remaining lug bolts.

Tighten all the bolts securely in a diag-

onal pattern

5. Lower the vehicle and remove the jack

from beneath the vehicle.

Following installation

1. Tighten the lug bolts in a diagonal pat-

tern

To ensure safety, always have the

lug bolts checked with a cali-

brated torque wrench as soon as possi-

ble to ensure that they are tightened to

the specified torque. The tightening

torque is 140 Nm.<

2. Reverse the removal sequence when

storing the wheel and tools in the vehi-

cle

Online Edition for Part-No. 01 41 0 159 154 - © 09/04 BMW AG

1 2 ... 202 203 204 205 206 207 208 209 210 211 212 ... 238 239

Kommentare zu diesen Handbüchern

Keine Kommentare