BMW 135i Bedienungshandbuch PDF herunterladen (Seite 85)

Reference At a glanceControlsDriving tipsMobility

83

Adaptive light control*

The concept

Adaptive light control is a variable headlamp

control system that enables better illumination

of the road surface. Depending on the steering

angle and other parameters, the light from the

headlamp follows the course of the road.

In tight curves at speeds up to 40 mph/70 km/h,

e.g. on mountainous roads or when turning, an

additional, corner-illuminating lamp is switched

on that lights up the inside area of the curve.

Activating adaptive light control

With the ignition switched on, turn the light

switch to position 3, refer to page 81.

The corner-illuminating lamp is switched on

automatically, depending on the steering wheel

angle or turn signal indicator.

Standstill function

*

: to avoid blinding oncoming

traffic, the adaptive light control directs light

towards the front passenger side when the

vehicle is at a standstill.

When you are reversing, only the corner-illumi-

nating lamps are switched on and active on

both sides.

Malfunction

The LED next to the symbol for automatic head-

lamp control flashes. Adaptive light control is

malfunctioning or has failed. Have the system

checked as soon as possible.

High beams/roadside parking

lamps*

1 High beams

2 Headlamp flasher

3 Roadside parking lamps

*

Roadside parking lamps, left or right*

There is an additional option of switching on the

lamps on the side of the car facing the road

when parked.

Switching on

After parking the vehicle, press the lever up or

down beyond the pressure point for approx.

1 second, arrow 3.

The roadside parking lamps drain the bat-

tery. Therefore, do not leave them on for

unduly long periods of time; otherwise, the bat-

tery might not have enough power to start the

engine.<

Switching off

Press the lever in the opposite direction to the

pressure point, arrow 3.

High-beam assistant*

The concept

This system automatically switches the high

beams on and off. The procedure is controlled

by a sensor on the front of the interior rearview

mirror. The assistant ensures that the high

beams are switched on whenever the traffic sit-

uation allows. It handles this task for you and

gives you the benefit of the best possible view.

You can intervene at any time and switch the

high beams on and off as usual.

Activating the system

1. Turn the light switch to position 3, refer to

page 81.

2. With the low beams switched on, briefly

push the turn signal/high beam lever in the

direction of the high beam.

Online Edition for Part no. 01 41 2 604 079 - © 02/10 BMW AG

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 175 176

Kommentare zu diesen Handbüchern

Keine Kommentare