BMW M3(E36) Installationsanleitung PDF herunterladen (Seite 19)

www.vf-engineering.com BMW E36 (‘96-’98 incl. ‘99 M3) US MODELS

PAGE 19 of 28 P/N: VFM28/38/40-01

Rev 1.10.25.06

36 Slide the supercharger discharge duct with silicon couplers and all clamps in place (at both ends of duct)

onto the supercharger while simultaneously connecting the hoses from the bypass valve and the Idle Air

Stabilizer to the underside of the duct. You can adjust fitment by trimming the length of the rubber hoses on

the bypass valve in the even that any components interfere with each other. Adjust and secure all couplers

until a complete seal is made. You may need to trim silicon couplers due to manufacturing tolerances.

Ensure you do not over tighten clamps or this will assert too much force on the plastic ducts.

(***NOTE: The appearance of your discharge duct may vary if your vehicle does/does not have traction

control, however the installation process is the same.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

Keine Kommentare

BMW M3(E36) Installationsanleitung Seite 19