Bmw 760i Sedan 2004 Bedienungsanleitung PDF herunterladen (Seite 64)

Driving

62

approx. 30 minutes or when you remove

the remote control from the ignition lock.

Remember to observe the Check Control

for status messages.<

Should exceptional circumstances

render it necessary for you to switch

off the engine while the vehicle is moving,

press the start/stop button for approx.

1 second.

If you maintain pressure on the start/stop

button for longer than two seconds while

switching off the ignition, the remote con-

trol will be ejected.<

Before leaving the vehicle, remove

the remote control from the ignition

lock; with Comfort Access, always take the

remote control with you.<

Parking brake

The concept

Your BMW is equipped with an electrome-

chanical parking brake.

The parking brake is primarily intended to

prevent the vehicle from rolling while

parked.

You can operate or use the parking brake in

two different ways:

> Manually, by briefly pressing the button

> Automatically, through activation of the

Automatic Hold mode, refer to page 63.

An electrohydraulic mechanism then

engages the parking brake to prevent the

rear wheels from turning whenever you

switch off the engine.

When the engine is running, parking brake

engagement is controlled by the brake sys-

tem's hydraulic circuits, which act on the

disc brakes at the front and rear wheels.

Brake pedal feel

Because this function is activated using

the brake system's hydraulic circuits, the

response of the brake pedal may change

slightly. Engagement may also be accom-

panied by activation noise – this is normal.

Manual engagement

Briefly press the button, the

word PARK appears briefly

in the Info Display. With the

parking brake set, the indicator

lamp lights up red in the

Info Display, refer to page 12.

With the ignition off, the indicator

lamp goes out after a brief

period.<

Manual release

With the ignition on, briefly

press the button: the indicator

lamp in the Info Display goes

out.

Provided that the remote control unit

is inserted in the ignition lock, you can

also release the parking brake after the

engine has been switched off. This function

is intended for use in automatic car

washes, etc.<

When leaving the vehicle, always

release the remote control from the

detent in the ignition lock; this precaution

prevents children from disengaging the

parking brake, etc.

The parking brake can still be engaged at

any time when the remote control unit is

released from the detent. It is only possible

to disengage the parking brake with the

ignition on.<

If exceptional circumstances should

make it necessary to engage the

parking brake while the vehicle is in motion,

maintain pressure on the button.

The indicator lamp appears in red in the

Info Display. A gong sounds at the same

Online Edition for Part No. 01 41 0 157 670 - © 08/03 BMW AG

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 231 232

Kommentare zu diesen Handbüchern

Keine Kommentare