Bmw 760i Sedan 2004 Bedienungsanleitung PDF herunterladen (Seite 114)

Practical interior accessories

112

The device can be operated as of ignition

on.

If the device cannot be operated

after repeated programming, check

whether the original hand-held transmitter

uses an alternating-code system. To do so,

either read the instructions of the original

hand-held transmitter or press and hold

down the programmed memory button 1 of

the integrated universal remote control.

If the indicator lamp 2 on the integrated

universal remote control flashes quickly for

a brief period and then remains lit up for

approx. two seconds, this indicates that

the original hand-held transmitter is

equipped with an alternating-code sytem.

In the case of an alternating-code system,

program the memory buttons 1 as

described at the section on alternating-

code transmitters.<

Alternating-code transmitters

Consult the operating instructions of the

unit you wish to set when programming the

integrated universal remote control. You

will find information there on the possibili-

ties for synchronization.

When programming hand-held transmitters

that employ an alternating code, please

observe the following supplementary

instructions:

Programming will be easier with the

aid of a second person.<

1. Park your vehicle within the range of the

remote-controlled device

2. Program the integrated universal

remote control as described at the sec-

tion on fixed-code hand-held transmit-

ters

3. Localize the button on the receiver of

the device you want to set up, e.g. on

the upper section of the motor

4. Press the button on the receiver of the

device you want to set up. After step 4,

you have approx. 30 seconds for step 5

5. Press the programmed memory

button 1 on the integrated universal

remote control three times.

The corresponding memory button 1 is

now programmed with the signal of the

original hand-held transmitter.

If you have any additional questions,

please contact your BMW center.<

Clearing memory buttons

Individual memory buttons 1 can not be

cleared. However, you clear all three mem-

ory buttons 1 together as follows:

Press both outer buttons 1 of the inte-

grated universal remote control for approx.

20 seconds, maintaining pressure until the

indicator lamp 2 starts to flash.

Roller sun blinds*

Roller sun blind for rear window

To actuate from the radio position, briefly

press the button in the driver's door.

Roller sun blinds for rear side

windows

Activate by briefly pressing the desired but-

ton with the ignition lock in the radio mode.

1 Quarter window blind

2 Side window blind

Online Edition for Part No. 01 41 0 157 670 - © 08/03 BMW AG

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 231 232

Kommentare zu diesen Handbüchern

Keine Kommentare