Bmw X5 3.0i SAV 2006 Bedienungsanleitung PDF herunterladen (Seite 63)

OverviewControlsMaintenanceRepairsDataIndex

63nStarting engine Switching off engine

Do not allow the engine to warm up by

leaving it running while the vehicle

remains stationary. Instead, begin to

drive immediately at a moderate engine

speed.

X5 3.0i:

Do not end the starting procedure too

soon, but do not continue for longer

than approx. 20 seconds. Release the

ignition key immediately as soon as the

engine starts.

X5 4.4i, 4.8is:

Your BMW is equipped with the conve-

nience starting feature. With this fea-

ture, it is sufficient to turn the ignition

key only briefly to position 3 'Start

engine' and to let go of it right away.

The starter actuation continues to oper-

ate automatically for a certain period of

time and is stopped automatically as

soon as the engine has started.

The automatic starting mode will not

operate or will be canceled if the bat-

tery voltage is insufficient. The engine

can be jump started, refer to page 174.

Should the engine fail to start on the

first attempt, if it is very hot or cold, for

instance:

> Press the accelerator pedal halfway

down while engaging the starter.

Cold starts at altitudes above 3,300 ft/

1,000 meters and at very low tempera-

tures, from approx. +57/–156:

> For the initial starting attempt, allow

the starter to remain engaged some-

what longer, approx. 10 seconds.

Engine idle speed is controlled by the

engine computer system. Increased

speeds at startup are normal and

should decrease as the engine warms

up. If engine speed does not decrease,

service is required.

To prevent the battery from being

drained, always switch off electrical

devices that are not in use. Switch the

ignition off when the vehicle is not

being driven.

Extended starting attempts, char-

acterized by excessively frequent

or long periods with the starter

engaged, can lead to damage of the

catalytic converter.<

Manual transmission:

1. Turn the ignition key to position 1

or 0

2. Shift into first gear or reverse.

Automatic transmission:

1. Shift into selector lever position P

2. Turn the ignition key to position 1

or 0.

Do not remove the ignition key

when the vehicle is moving, other-

wise, the steering could lock.

When leaving the vehicle, always

remove the ignition key and lock the

steering.

Manual transmission:

Always engage the handbrake when

parking on slopes and inclined sur-

faces. Even placing the gearshift lever

in 1st gear or reverse may not provide

adequate resistance to rolling.

Automatic transmission:

Place the selector lever in the P posi-

tion.<

Automatic transmission:

The vehicle must be stationary and the

selector lever in Park before you can

remove the ignition key.

Online Edition for Part No. 01 41 0 159 867 - © 07/05 BMW AG

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 201 202

Kommentare zu diesen Handbüchern

Keine Kommentare