BMW X3 xDrive28i Bedienungshandbuch PDF herunterladen (Seite 83)

System limits

Sudden tire damage

Sudden serious tire damage caused by

external influences cannot be indicated in ad‐

vance.◀

The system does not operate correctly if it has

not been reset. For example, a flat tire may be

indicated despite correct tire inflation pres‐

sures.

The system is inactive and cannot indicate a flat

tire:

▷ For a mounted wheel without TPM electron‐

ics.

▷ When the TPM is disturbed by other sys‐

tems or devices with the same radio fre‐

quency.

Status display

The current status of the Tire Pressure Monitor

TPM can be displayed on the Control Display,

e.g., whether or not the TPM is active.

"Vehicle Info"

2. "Vehicle status"

3. "Tire Pressure Monitor - TPM"

The status is displayed.

Resetting the system

Reset the system after each correction of the

tire inflation pressure and after every tire or

wheel change.

"Vehicle Info"

2. "Vehicle status"

3. "Reset TPM"

4. Start the engine - do not drive away.

5. Reset the tire pressure using "Reset".

6. Drive away.

The tires are shown in gray and "Resetting

TPM..." is displayed.

After driving for a few minutes, the set tire infla‐

tion pressures are applied as set values. The re‐

setting process is completed automatically dur‐

ing driving. The tires are shown in green and

"TPM active" is shown on the Control Display.

The trip can be interrupted at any time. If you

drive away again, the process resumes auto‐

matically.

If a flat tire is detected during a reset, all tires are

displayed in yellow.

Low tire pressure message

The yellow warning lamp lights up. A

Check Control message is displayed.

▷ There is a flat tire or a major loss in

tire inflation pressure.

▷ The system was not reset after a wheel

change and thus warns based on the infla‐

tion pressures initialized last.

1. Reduce your speed and stop cautiously.

Avoid sudden braking and steering maneu‐

vers.

2. Check whether the vehicle is fitted with reg‐

ular tires* or run-flat tires*.

Run-flat tires, refer to page 213, are labeled

with a circular symbol containing the letters

RSC marked on the tire sidewall.

When a low inflation pressure is indicated, DSC

Dynamic Stability Control is switched on if nec‐

essary.

Actions in the event of a flat tire

Normal tires*

Identify the damaged tire.

Do this by checking the air pressure in all

four tires.

If the tire inflation pressure in all four tires is

correct, the Tire Pressure Monitor may not

have been initialized. In this case, initialize

the system.

If an identification is not possible, please

contact the service center.

2. Rectify the flat tire on the damaged wheel.

Use of tire sealant, e.g., the Mobility System,

may damage the TPM wheel electronics. In

this case, have the electronics checked at

Seite 83

Online Edition for Part no. 01 40 2 606 190 - 12 10 500

Reference Mobility Communication Entertainment Navigation Driving tips Controls At a glance

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 261 262

Kommentare zu diesen Handbüchern

Keine Kommentare

BMW X3 xDrive28i Bedienungshandbuch Seite 83

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Autos BMW X3 xDrive28i