BMW M1 Coupe Bedienungshandbuch PDF herunterladen (Seite 35)

34

Mobility Replacing components

8. With the ignition switched on or the engine

running, switch on the compressor.

Let the compressor run for approx. 3 to

8 minutes to fill the tire with sealant and

achieve a tire inflation pressure of approx.

36 PSI/250 kPa.

9. Switch off the compressor.

While the tire is being filled with sealant, the dis-

played inflation pressure may briefly reach

approx. 73 PSI/500 kPa. Do not switch off the

compressor in this phase.

Do not run the engine in enclosed areas;

otherwise, the inhalation of toxic exhaust

gases can cause loss of consciousness and

death. The exhaust gases contain carbon

monoxide, an odorless and colorless, but highly

toxic gas.<

Do not let the compressor run for more

than 10 minutes, otherwise the device will

overheat and may be damaged.<

If an inflation pressure of 29 PSI/2 bar cannot be

reached:

1. Switch off the compressor.

2. Unscrew the filler hose from the tire valve.

3. Drive 33 ft/10 m forward and in reverse to

distribute the sealing compound in the tire.

4. Inflate the tire again with the compressor.

If an inflation pressure of 29 PSI/200 kPa

still cannot be reached, the tire is too heavily

damaged. Contact your BMW center.

Stowing Mobility System

1. Unscrew the filler hose of the sealant bottle

from the tire valve.

2. Unscrew the connecting hose of the

compressor from the sealant bottle.

3. Connect the filler hose of the sealant bottle

to the unoccupied connection on the

sealant bottle.

This prevents the rest of the sealant from

escaping from the bottle.

4. Wrap the empty sealant bottle in suitable

material to avoid dirtying the cargo area.

5. Stow Mobility System back in the vehicle.

Distributing the sealant

Immediately drive approx. 3 miles/5 km to

evenly distribute the sealant in the tire.

Do not exceed a speed of 50 mph/

80 km/h. If possible, do not fall below a

speed of 12 mph/20 km/h.<

Correcting the tire inflation pressure

1. Stop at a suitable location.

2. Connect connecting hose of the compres-

sor directly to the tire valve.

3. Insert the plug into the power socket in the

vehicle interior.

4. Adjust the tire inflation pressure to 36 PSI/

250 kPa. With the engine running:

> To increase the inflation pressure: With

the ignition switched on or the engine

running, switch on the compressor.

To check the inflation pressure, switch

off the compressor.

> To reduce the inflation pressure: Press

the discharge button on the compres-

sor.

If the inflation pressure is not maintained,

drive the vehicle a second time, refer to

Distributing the sealant. Then repeat steps 1

to 4.

Online Edition for Part no. 01 40 2 609 935 - © 08/11 BMW AG

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 47 48

Kommentare zu diesen Handbüchern

Keine Kommentare