BMW E46/2 Coupe Bedienungsanleitung PDF herunterladen (Seite 16)

2.6 Installation of power supply wiring harness

Open fold-out page 2-73 !

Only E46/2

Guide the power supply wiring harness (1) from the PDC control unit in the boot through the grommet (2) on the

right behind the rear seat bench and install it along the right sill strips to the fuse box above the glove box.

In right-hand drive models, the same installation route of the power supply wiring harness as in left-hand drive

models should be adhered to. For this purpose, the ties on the power supply wiring harness must be opened

up.

Only E46/C

Install ultrasonic sensor wiring harness (1) through the cable guide from the boot into the rear compartment.

Install the power supply wiring harness (2) from the installation location of the PDC control unit to the fuse box

above the glove box.

All models

Insert branch cable B of the power supply wiring harness, cable colour green/white, into the fuse holder II, A47 (1)

(X10016), plug-in place F 24, Pin 48 and put in 5A flat-bladed fuse (2).

Plug in cables of the power supply wiring harness into the respective joint connectors of the joint connector box

(1) as follows:

Only vehicles without gong fitted

Cable A1 with cable colour blue/yellow connector X428

Cable A2 with cable colour brown connector X219

Cable A3 with cable colour white/red/yellow connector X10116

Cable A4 with cable colour red/yellow connector X10189

Only vehicles with gong fitted

Cable A1 with cable colour blue/yellow connector X428

Cable A3 with cable colour white/red/yellow connector X10116

Tie back branch cables A2 and A4 which are not required.

Only vehicles without gong fitted

Cut out pre-punched aperture (1) for the gong (2) out of the foot-well trim panel on the driver’s side (3) and insert

the gong (2).

Insert socket contact D1, cable colour blue/grey, in the 1-pole socket housing D. Insert socket contact C1, cable

colour brown, in the 3-pole socket housing C, Pin 1, and insert socket contact C2, cable colour red/yellow, in the

3-pole socket housing C,Pin 3.

Plug in socket housings (D, C) into the relevant plug-in places on the gong as follows:

1-pole socket housing D in plug-in place T4 (X 363)

3-pole socket housing C in plug-in place T3 (X 522)

Vehicles with gong fitted

Insert socket contact D1 with cable colour blue/grey into the 1-pole socket housing D and insert into the plug-in

place T4 (X363) on the gong.

Tie back not needed cable.

EN/2-59

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22

Keine Kommentare

BMW E46/2 Coupe Bedienungsanleitung Seite 16