BMW 325i Bedienungshandbuch PDF herunterladen (Seite 114)

114n

To ensure maximum economy and a

long service life, we request that you

observe the following suggestions.

Engine and differential

Up to 1,200 miles (2,000 km):

Drive at varying engine speeds and road

speeds, but do not exceed the following

engine or road speeds during this time:

4,500 rpm or 100 mph (160 km/h).

Obey your local and state maximum

speed limits.

Refrain from using full throttle and avoid

pressing the accelerator beyond the

"kickdown" point.

After you have driven 1,200 miles

(2,000 km), you can gradually increase

the engine and road speeds.

You should also comply with these

break-in procedures if the engine or

differential is replaced at a later point.

Tires

Due to technical factors associated

with their manufacture, tires do not

achieve their full traction potential until

an initial break-in period has elapsed.

Thus drive with extra care during the

initial 200 miles (300 km).

Obey your local and state maximum

speed limits.

When the vehicle is operated on

wet or slushy roads, a wedge of

water may form between the tire and

the road surface. This phenomenon is

referred to as aquaplaning, or hydropla-

ning, and can lead to partial or

complete loss of traction, vehicle

control and braking effectiveness.

Reduce your speed on wet roads.<

Brake system

After approximately 300 miles (500 km),

the brake pads and discs achieve the

optimal pad surface and wear patterns

required for trouble-free operation and

long service life.

To break in the separate parking brake

drums, apply the parking brake lightly

when coasting to a standstill (at a traffic

signal, for instance), provided that

traffic conditions allow you to do so.

To avoid corrosion, repeat this proce-

dure from time to time.

The brake lamps do not come on

when the parking brake is applied.

Vacuum for the brake system servo unit

on your BMW is available only when the

engine is running. When you move the

vehicle with the engine off – when

towing, for example – substantially

higher levels of pedal force will be

required to brake the vehicle.<

Clutch

The clutch will also begin to function

optimally after about 300 miles

(500 km). Engage the gears carefully

during the break-in period.

Break-in procedures

Online Edition for Part No. 01 41 0 155 307 - © 09/00 BMW AG

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 202 203

Kommentare zu diesen Handbüchern

Keine Kommentare