Bmw 325Ci Coupe 2005 Bedienungsanleitung PDF herunterladen (Seite 144)

144

Coolant

Do not add coolant to the cooling

system when the engine is hot. If

you attempt to do so, escaping coolant

can cause burns.<

Coolant consists of water as well as an

additive such as antifreeze with corro-

sion inhibitor. Not all commercially

available additives are suitable for your

BMW. Your BMW center knows which

additives are appropriate.

Only use approved additives, as

the engine could otherwise be

damaged. The additives are hazardous

to your health; therefore, follow the

instructions on the containers.<

Comply with the applicable envi-

ronmental laws regulating the dis-

posal of antifreeze with corrosion inhib-

itor.<

Checking the coolant level and

adding coolant

Check the coolant level when the

engine is cold, approx. 687/+206.

1. Open the cap for the expansion tank

by turning it slightly counterclock-

wise to allow accumulated pressure

to escape, then open

2. The coolant level is correct when the

upper end of the red float rod – see

arrow – is at least even with the

upper edge of the filler neck, is at

least even with the upper edge of the

filler neck; see arrow. The end of the

float may stick out by a maximum of

3/4 in / 2 cm – that is, up to the sec-

ond mark on the float

3. If necessary, add coolant. If the cool-

ant is low, slowly add coolant until

the correct level is reached – do not

overfill.

1 2 ... 139 140 141 142 143 144 145 146 147 148 149 ... 189 190

Keine Kommentare

Bmw 325Ci Coupe 2005 Bedienungsanleitung Seite 144