BMW 2009 X3 Bedienungshandbuch PDF herunterladen (Seite 71)

Reference At a glanceControlsDriving tipsMobility

69

Practical interior accessories

Integrated universal remote

control*

The concept

The integrated universal remote control can

replace as many as three hand-held transmit-

ters for various radio-controlled accessories,

such as garages, exterior gates, or lighting sys-

tems. The integrated universal remote control

recognizes and learns the transmitted signal of

each of the original hand-held transmitters.

The signal of an original hand-held transmitter

can be programmed on one of the three mem-

ory buttons 1. Then, the programmed memory

button 1 can operate the device whenever the

ignition is switched on. The LED 2 indicates

transmission of the signal.

Should you sell your vehicle one day, be sure to

delete the stored programs beforehand for your

security, refer to page 70.

To prevent possible damage or injury,

before programming or using the inte-

grated universal remote control, always inspect

the immediate area to make certain that no peo-

ple, animals or objects are within the travel range

of the device. Also, comply with the safety pre-

cautions of the original hand-held transmitter.<

Checking compatibility

If you see this symbol on the packaging

or in the manual supplied with the origi-

nal hand-held transmitter, then it is safe

to assume that the radio-controlled device is

compatible with the integrated universal

remote control.

If you have additional questions, please

ask at your BMW Sports Activity Vehicle

Center or call: 1-800-355-3515.

You can find also information on the Internet at:

www.bmwusa.com or

www.homelink.com.

HomeLink is a registered trademark of

Johnson Controls, Inc.<

Programming

1 Memory buttons

2 LED

Fixed-code hand-held transmitters

1. Turn the ignition key to position 2.

2. For initial use: press the left and right mem-

ory button 1 for approx. 20 seconds until

the LED 2 flashes rapidly. All stored pro-

grams are deleted.

3. Hold the original hand-held transmitter at a

distance of approx. 4 in/10 cm to 12 in/

30 cm from the memory buttons 1.

The required distance between the

hand-held transmitter and memory

buttons 1 depends on the relevant system

of the original hand-held transmitter used.<

4. Simultaneously press the transmit button

on the original hand-held transmitter and

the desired memory button 1 of the inte-

grated universal remote control. Initially, the

LED 2 flashes slowly. Release both buttons

as soon as the LED 2 flashes rapidly. If the

LED 2 does not flash rapidly after approx.

15 seconds, then change the distance and

repeat the step.

5. To program other original hand-held trans-

mitters, repeat steps 3 and 4.

The corresponding memory button 1 is now

programmed with the signal of the original

hand-held transmitter.

You can use the system when the engine is run-

ning or when the ignition is switched on.

Online Edition for Part no. 01 41 2 601 104 - © 08/08 BMW AG

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 145 146

Kommentare zu diesen Handbüchern

Keine Kommentare