BMW G 650 XMOTO Wartungshandbuch PDF herunterladen (Seite 90)

Begin by connecting one

end of the red jump lead

to the positive terminal 3 of

the discharged battery and

the other end to the pos-

itive terminal of the donor

battery.

Connect the black jumper

cable to the negative termi-

nal of the supporting bat-

tery and then to a suitable

grounding point of this mo-

torcycle.

Start engine of motorcycle

with discharged battery in

usual way; if engine refuses

to start, wait a few minutes

before repeating attempt to

protect starter and support-

ing battery.

Allow both engines to idle

for a few minutes before

disconnecting jump leads.

First disconnect jumper ca-

bles from negative terminal

and from grounding point

respectively, then from posi-

tive terminal 3.

To start the engine, do

not use start sprays or

similar items.

Installing right fairing side

panel ( 91)

Battery

Maintenance instructions

Correct upkeep, recharging

and storage will prolong the

life of the battery and are es-

sential if warranty claims are

to be considered.

Compliance with the points

below is important in order to

maximize battery life:

Keep the surface of the bat-

tery clean and dry

Do not open the battery

Do not top up with water

Be sure to read and com-

ply with the instructions for

charging the battery on the

following pages

Do not turn the battery up-

side down

If the battery is not

disconnected, the

onboard electronics (clock

etc.) will drain the battery.

This can cause the battery

to run flat. If this happens,

warranty claims will not be

accepted.

During periods when the mo-

torcycle is not being used, of

more than four weeks, dis-

connect the battery from the

7

88

z

Maintenance

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 131 132

Kommentare zu diesen Handbüchern

Keine Kommentare