Bmw X3 3.0i SAV 2004 Bedienungsanleitung PDF herunterladen (Seite 101)

Reference At a glanceControlsDriving tipsMobility

99

Replacing components

Onboard tool kit

The onboard tool kit is located in a com-

partment on the left under the cargo area.

Replacing wiper blades

Front

1. Move the wiper to a fold-out position,

refer to page 42

2. Lift the wiper arm and press the secur-

ing spring, refer to arrow

3. Pull the wiper blade off toward the

wiper arm

4. Insert the new blade and snap it into

place.

Fold the wipers back down onto the

windshield before you turn the igni-

tion key to position 1 or 2 again. If you do

not, they could be damaged.<

Rear

1. Lift the wiper arm

2. Pull off the wiper blade, refer to arrow

3. Insert a new wiper blade.

Lamps and bulbs

The lamps and bulbs make essential contri-

butions to the safety of your vehicle. There-

fore, comply fully with the following instruc-

tions during bulb replacement. If you are

not familiar with the specified procedures,

BMW recommends having the replace-

ments carried out at your BMW Sports

Activity Vehicle Center.

Never touch the glass of new bulbs

with your bare fingers, as even minute

amounts of contamination will burn into the

bulb's surface and reduce its service life.

To install, use a clean cloth, napkin etc. or

hold the bulb by its metal socket.<

A replacement bulb set is available from

your BMW Sports Activity Vehicle Center.

To prevent short circuits, before

working on any electrical system,

equipment or accessory you should always

switch it off and disconnect the cable from

the battery's negative terminal before start-

ing.

To avoid possible injury or equipment dam-

age when changing bulbs, observe any

instructions provided by the bulb manufac-

turer.<

Online Edition for Part No. 01 41 0 157 631 - © 07/03 BMW AG

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 131 132

Kommentare zu diesen Handbüchern

Keine Kommentare