Bmw M6 Convertible 2010 Bedienungsanleitung PDF herunterladen (Seite 197)

Mobility

195

Reference At a glanceControlsDriving tipsCommunications NavigationEntertainment

> "Measurement not possible at this time."

> "Measuring engine oil level...":

This can take about 3 minutes if the car is at

a standstill on a level surface and the engine

is running, and about 5 minutes while the

car is moving.

If the engine oil has been topped off, the

measurement of the oil level can take up to

30 minutes.

> "Engine oil level below minimum. Add 1

quart!":

Add a maximum of 1 US quart/1 liter of

engine oil at the next opportunity, refer also

to Adding engine oil below. If the oil level

displayed is below minimum, add engine oil

immediately. Failure to do so may lead to

engine damage.

> "Engine oil level too high! Have this

checked.":

Too much oil will harm the engine.

Have the vehicle checked without

delay.<

> "Measurement inactive. Have this

checked.":

Do not add engine oil. You can continue

your journey. Note the newly calculated dis-

tance remaining to the next oil service, refer

to Service requirements on page 68. Have

the system checked as soon as possible.

Adding engine oil

Do not add oil until a value slightly above the

minimum of 0.0 US quarts/liters is displayed by

the oil level measurement. In this area a mes-

sage is also shown on the Control Display.

Add oil within the next 125 miles/200 km,

otherwise the engine could be damaged.

Add a maximum of 1 US quart/1 liter of oil; oth-

erwise, the engine may be damaged by adding

too much oil.

Add at least 0.5 US quart/0.5 liter of oil; other-

wise, the oil level check cannot reliably display

the current oil level.<

Please conduct a fast measurement after

adding engine oil to check the oil quantity

added and to update the display.<

Continuous exposure to used oil has

caused cancer in laboratory testing.

For this reason, thoroughly wash exposed areas

of skin with soap and water after such work.

Keep oil, grease etc. out of reach of children and

observe the warnings on the containers to pre-

vent health risks.<

Oil change

Have oil changed only at your BMW center or

at a workshop that works according to BMW

repair procedures with correspondingly trained

personnel.

Approved engine oils

The quality of the engine oil selected has critical

significance for the operation and service life of

an engine. BMW continuously approves spe-

cific oils after confirming their suitability for use

in its vehicles with extensive testing.

Do not use oil additives; under some cir-

cumstances, they can damage your

engine.<

Your BMW center will be happy to answer

detailed questions on BMW High Perfor-

mance Synthetic Oil or approved synthetic

oils.<

You can also call BMW of North America at

1-800-831-1117 or visit the website at

www.bmwusa.com to obtain this information.

Viscosity grades

Viscosity is a measure of an oil's flow rating and

is specified in SAE grades.

Approved oils belong to the SAE grade

10W-60.<

1 2 ... 192 193 194 195 196 197 198 199 200 201 202 ... 249 250

Kommentare zu diesen Handbüchern

Keine Kommentare

Bmw M6 Convertible 2010 Bedienungsanleitung Seite 197

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Autos Bmw M6 Convertible 2010