Bmw M5 Sedan 2008 Bedienungsanleitung PDF herunterladen (Seite 221)

Mobility

219

Reference At a glanceControlsDriving tipsCommunications NavigationEntertainment

4. Screw dust cap off valve of defective wheel

and screw filling hose 2 of sealant bottle

onto valve.

5. Insert sealant bottle on compressor hous-

ing so that it is positioned upright.

6. Make sure that the device is switched off,

position 0.

7. Insert connector 3 into lighter socket in

vehicle interior, refer to page 108.

8. With the ignition switched on:

Switch on the device and allow to run for

approx. 3 minutes to fill wheel with sealant.

It is not important what inflation pressure

the tire has after filling.

9. Switch off device.

10. Remove connecting hose from connection

of sealant bottle and tire valve.

Stow the M Mobility System in the vehicle

again.

Distributing sealant

Immediately drive approx. 2 miles/3 km so that

sealant is evenly distributed in tire.

Do not exceed a maximum speed of

35 mph/60 km/h. Do not drop below

12 mph/20 km/h if possible.<

Producing tire inflation pressure

1. After approx. 2 miles/3 km, stop at suitable

location.

2. Screw compressor hose 9 directly onto tire

valve.

3. Insert connector 3 in lighter socket in vehi-

cle interior.

4. Correct tire inflation pressure to 29 psi/

200 kPa. With the ignition switched on:

> Increase inflation pressure: switch on

compressor, position I. To check cur-

rently set inflation pressure, briefly

switch off device.

Do not allow compressor to run

longer than 10 minutes, otherwise

the device will overheat and may be dam-

aged.<

> Reduce inflation pressure: press

button 8 or turn screw 8 on pressure

gauge.

If the inflation pressure is not held, drive

the vehicle again, refer to Distributing

sealant. Then repeat steps 1 to 4 once.

Using the M Mobility System can be ineffective

with tire damage from a size of approx. 0.16 in/

4 mm. Please contact the nearest BMW center,

refer to page 224, or a workshop that works

according to BMW repair procedures with cor-

respondingly trained personnel if the tire can-

not be made ready for driving with the

M Mobility System.<

The tire inflation pressure must be at least

29 psi/200 kPa. Otherwise do not con-

tinue driving.<

Continue driving

Do not exceed the permissible maximum

speed of 50 mph/80 km/h, otherwise

accidents can occur.<

Reinitialize the Flat Tire Monitor.

For details, refer to page 83.

Have the defective tire and the sealant bottle of

the M Mobility System replaced as soon as

possible.<

Changing wheels*

Safety precautions in the event of a flat

tire or wheel change: park the vehicle as

far as possible from passing traffic and on solid

ground. Switch on the hazard warning flashers.

Apply the handbrake and shift into first gear or

reverse with the manual transmission, or move

Online Edition for Part no. 01 41 0 014 238 - © 08/07 BMW AG

1 2 ... 216 217 218 219 220 221 222 223 224 225 226 ... 259 260

Kommentare zu diesen Handbüchern

Keine Kommentare