BMW ONBOARD COMPUTER Wartungshandbuch PDF herunterladen (Seite 116)

Run the engine of the donor

vehicle during jump-starting.

Begin by connecting one end

of the red jump lead to posit-

ive terminal 2 of the discharged

battery and the other end to

the positive terminal of the

donor battery.

Then connect one end of the

black jump lead to the negative

terminal of the donor battery

and the other end to negative

terminal 1 of the discharged

battery.

Start the engine of the vehicle

with the discharged battery

in the usual way; if the en-

gine does not start, wait a few

minutes before repeating the

attempt in order to protect the

starter motor and the donor

battery.

Allow both engines to idle for a

few minutes before disconnect-

ing the jump leads.

Disconnect the jump lead from

the negative terminals 1 first,

then disconnect the second

jump lead from the positive

terminals 2.

Do not use proprietary

start-assist sprays or oth-

er products to start the engine.

Install the centre trim panel

( 117).

Battery

Maintenance instructions

Correct upkeep, recharging and

storage will prolong the life of

the battery and are essential if

warranty claims are to be con-

sidered.

Compliance with the points be-

low is important in order to max-

imise battery life:

Keep the surface of the battery

clean and dry

Do not open the battery

Do not top up with water

Be sure to read and comply

with the instructions for char-

ging the battery on the follow-

ing pages

Do not turn the battery upside

down

If the battery is not discon-

nected, the on-board elec-

tronics (e.g. clock, etc.) gradually

drain the battery. This can cause

the battery to run flat. If this hap-

pens, warranty claims will not be

accepted.

If the motorcycle is to be out of

use for more than four weeks,

disconnect the battery or con-

8

114

z

Maintenance

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 154 155

Kommentare zu diesen Handbüchern

Keine Kommentare