with BMW Motorrad ABS
OE
Insert the ABS sensor into its
bore and install screw 1.
Remove the auxiliary stand, if
installed beforehand.
Remove the rear wheel
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Remove screw 1 and remove
the speed sensor from its bore.
Make sure the ground is level
and firm and place the mo-
torcycle on a suitable auxiliary
stand.
with centre stand
OA
Make sure the ground is level
and firm and place the motor-
cycle on its centre stand.
Remove axle nut 2.
Slacken locknuts 3 on left and
right by turning them counter-
clockwise.
Back off adjusting screws 4 on
left and right by turning them
counter-clockwise.
Remove adjusting plate 5 and
push the axle in as far as it will
go.
8
102
z
Maintenance
Kommentare zu diesen Handbüchern