34.10
34 52 111 Removing and installing rear
Integral ABS sensor
•
Remove front and rear seats.
•
Remove right case, if necessary.
•
Remove small right side fairing panel.
•
Remove the cable ties securing the sensor ca-
ble.
•
Disconnect plug (1) of sensor cable.
•
Before removing/installing, clean the sensor
bore.
•
Remove sensor (2).
•
Installation is the reverse of the removal proce-
dure.
•
Coat O-rings with oil before installing.
e Attention:
Route the sensor cable correctly.
X Tightening torque:
Sensor ........................................ hand-tight, 4 Nm
1
2
R22340070
Kommentare zu diesen Handbüchern