00.44
34 00 080 Bleeding/changing brake fluid
in rear wheel circuit
e Attention:
Integral brakes, the front brake must be ready for
use.
•
Remove fuel tank.
e Attention:
Do not allow brake fluid to come into contact with
painted parts of the motorcycle as brake fluid de-
stroys paint.
•
Open rear wheel-circuit reservoir (1).
•
Draw off the old brake fluid from the wheel-circuit
reservoir.
•
Remove rear brake pads.
•
If necessary, manually push back brake piston
far enough to permit installation of resetting
tool, BMWNo.341531.
e Attention:
Install piston resetting tool, BMW No. 34 1 531 only
when the cap has been removed from the wheel-cir-
cuit reservoir.
•
Install adapter, BMW No. 34 1 536, instead of
the outboard brake pad.
•
Install resetting tool, BMW No. 34 1 531, with
the handle toward the outside in the rear brake
caliper, press the pistons fully back and secure
them in this position.
•
Wrap a cloth around the brake caliper.
– [Bleeding only] Bleed the rear wheel circuit.
(
a 00.47)
•
Draw off the old brake fluid from the wheel-circuit
reservoir.
•
Screw container, BMW No. 34 1 581,
onto rear wheel circuit reservoir.
•
Slowly fill container, BMWNo.341581, with
new brake fluid until it is approximately 1/3 full.
•
Connect the brake bleeding device to the bleed
screw, but do not switch on the device.
L Note:
If necessary, use a cable tie to secure the bleed
hose to the bleed screw.
R28340110
1
R28000170
34 1 536
34 1 531
R22000350
34 1 581
Kommentare zu diesen Handbüchern