BMW Z3 coupe Bedienungsanleitung PDF herunterladen (Seite 8)

ProjectorZ™

Installation Instructions

BMW Z3/Coupe and ///M Roadster/Coupe

8 of 8

Next, Connect the new H9’s with the plug and play harnesses that

came in your bezel and accessory kit. Connect the low and high beam

Hellas to your stock wiring using the plug and plays. Reinsert your

parking light bulb/wiring.

For DDE Lightning Plus™ Installs Only

To power the DDE Lightning Plus™ it is suggested that you use the

wiring harness specifically supplied with your kit. It is fuse and relay

protected.

Connect the large yellow battery lug to the battery post under the

hood. Secure the relay and brown ground wire to the nearby stud or

other chassis ground.

Route the harness to each headlight area along the fender sides.

Secure the long side across the back of the engine bay. It can run

under or along the wiring chase and be secured with the supplied tie

wraps.

Plug the color coded harness power wires into the wiring for the DDE

Lightning Plus™ power supplies on each headlight. Using the supplied

blue 3M Add-a-Tap connector, tap the red/white trigger wire of the

harness to the power wire to your parking lights on the driver’s side.

Alternatively the wire can be tapped into any switched power wire

under the hood you wish to use. You may need to extend the wire if

you do not use the parking lamp as a triggering power source.

1 2 3 4 5 6 7 8

Keine Kommentare

BMW Z3 coupe Bedienungsanleitung Seite 8