BMW Z3 coupe Bedienungsanleitung PDF herunterladen (Seite 7)

ProjectorZ™

Installation Instructions

BMW Z3/Coupe and ///M Roadster/Coupe

7 of 8

The new mounting brackets are now ready to install into the headlight.

All of the hard part is done. The new bracket and Hellas will reattach

to the factory levelers using the factory mounting points.

If you wish to remove the factory bubble level and silicone it to the

new bracket, it will function correctly, although it is not required for

operation.

Reassemble the back of the headlight by snapping the large black

mounting point in. Remember it pushes in sideways. Then push

straight down on the other two white nylon mounts until they snap into

place.

That’s it for that step. Repeat on the other headlight.

Now guide the back of the headlight onto the main part of the headlight

body, feeding the Hella units through the bezels and CNC machined

rings. The picture shown has the front of the light removed for clarity.

Be certain to observe from the front the wiring for the DDE Lightning

Plus™ as you push the light through. You want to make sure the

wiring comes through on the top, evenly. It is a tight fit but there is

room for the wiring between the Hella housing and the CNC trim ring.

There will also be clearance for the adjusters to operate. You will also

want to feed the wire leads from the halos to the white supply leads on

the power supply screwed to the mounting bracket before completely

assembling the lamp back onto the base of the headlight. Either halo

can plug into either white pair on the power supply.

Repeat for the other headlight. Press the back onto the headlight

tightly, place back into the oven at 200 degrees Fahrenheit (93 degrees

Celsius) for 2 minutes to soften the glue. Remove and press the back

fully onto the main base of the headlight until the latches snap back

into place. Set aside to cool. Repeat for the other headlight.

1 2 3 4 5 6 7 8

Keine Kommentare

BMW Z3 coupe Bedienungsanleitung Seite 7