BMW Z3 coupe Bedienungsanleitung Seite 5

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 8
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 4
ProjectorZ
Installation Instructions
BMW Z3/Coupe and ///M Roadster/Coupe
5 of 8
Once you have the lenses out, fit the new bezels into the old openings.
Note the shape of each removed lens and replace with the properly
shaped new black bezel with CNC aluminum trim.
Silicone them into place with black or clear silicone sealant around the
rear side edges. Let them set up for approximately 1-2 hours or until
the glue has set and is firm to the touch. 100% silicone is
recommended for durability and temperature tolerance. Silicone will
cure quicker at room temperature. If working in a cold garage, bring
the lights into the house to cure.
If you have the DDE Lightning Plus™ option, pull the power wires for
the halos gently back into the light base and tape up and out of the
way until the glue sets. The new Hella lamps will need to be inserted
through the openings in the bezel and you will want to have the DDE
Lightning Plus™ halo wires at the top of the opening and out of the
way to slide the Hella lamps in.
Repeat to this step on the other headlight and allow the silicone on all
four bezels to fully cure. Ensure that the bezels sit flat into the
headlight opening as they cure so they remain perfectly flat and fully
seated. The headlight may need to be supported to maintain the
correct angle.
Now let’s turn our attention back to the rear portion of each light that
we took off of the main lamp assembly. They should be cool and the
glue should be firm again so they can be handled more easily.
We will be removing the reflector from each rear headlight section.
The reflector is held into the back of the headlight at 3 positions. One
position is a large black socketed push-in connector and the other two
are smaller white nylon ball and socket type connectors.
Pull straight up at the two white connectors and they will pop free.
Reach in with a screwdriver and push the large, black, socketed
connector off to the side.
The reflector will pop free.
Seitenansicht 4
1 2 3 4 5 6 7 8

Kommentare zu diesen Handbüchern

Keine Kommentare