BMW R1100 Spezifikationen PDF herunterladen (Seite 6)

Lube and Adjust Clutch Cable

adjust maximum slack at clutch lever, at rear of transmission pry clutch release arm to

release the clutch cable there, lube both ends of clutch cable with BMW #10 grease,

reattach cable, using the knurled adjuster at the hand lever adjust to 12mm between it

and the knurled locknut, at clutch release arm loosen the 13mm locknut using 13mm

deepwell socket and swivel, adjust the 10mm bolt to give 7mm freeplay at the hand

clutch lever, pull in the hand clutch lever while tightening the locknut at the rear clutch

arm (see Paul Glaves and Bob Gorman "Clutch Adjustment")

Lube Front Shock Lower Mount

remove nut (15mm), remove bolt (14mm), lube bushing with BMW #10 grease, install

bolt (second person needed at rear of bike), torque to 37 ft.lb. (50 Nm)

Lube Side Stand and Center Stand

grease fitting on some RS’s only, others lube with WD40 if necessary

Check Brakes

check brake fluid levels front and back, check brake pads for wear, bleed brakes yearly

(see Carl Kulow “Brake Pad Replacement” and Stephen Karlan “Brake Bleeding”)

Inspect Battery

remove tank trim (R1100R) or side panels, remove tank bolt on right side, RS – remove

screws that attach front of tank to fairing, slide tank back and set on chair, fill battery

with distilled water, grease battery posts, leave tank off if doing a fuel filter change

Replace Fuel Filter

need: siphon, fuel filter, large o-ring, 2 small clamps, 2 tiny pencil size clamps, empty

gas can, rubber gloves, 8mm socket, replace every 24K miles, siphon gas from tank,

remove tank, with pencil mark orientation of plate to tank, with tank on side remove the

fuel pump plate using 8mm socket, disconnect fuel overflow and vent hoses (two small

inside hoses) remove unit from tank, replace fuel filter noting flow direction, reconnect

using two small screw clamps, insert new o-ring into tank groove, insert unit into tank,

reconnect two small hoses being sure to connect striped hose to striped hose using two

tiny clamps, tighten plate, install tank, check for leaks (see Jon Diaz "Fuel Filter

Change")

Test Ride Bike

(ride ~15 min. to get bike to operating temperature for throttle body sync)

1 2 3 4 5 6 7 8 9 10 11 ... 63 64

Keine Kommentare

BMW R1100 Spezifikationen Seite 6