BMW R1100 Spezifikationen PDF herunterladen (Seite 5)

R1100 Maintenance Steps - Carl Kulow

Note: This overview section serves only as a step by step reminder for experienced

workers. If you are unfamiliar with any procedure you should read the parenthetical

reference article or Paul Glaves’ Routine R1100 Service Article!

Note to R1100RT and R1100RS Riders: remove the side panels as described in your

owners manual “Service and Technical Booklet” except RT: instead of pulling the mirror

off as the manual says, you need to hold the back of the mirror (front of bike) with one

hand while you hit the front outside corner of the mirror with the palm of your hand thus

knocking the mirror off.

Check Alternator Belt

remove four bolts holding black plastic cover(4mm hex), remove cover, check belt for

cracks etc., check belt tension, replace belt every 36K miles, leave cover off for valve

adjustment (see Jon Diaz "Alternator Belt Adjustment")

Adjust Valves

remove black plastic valve cover protectors (5mm hex) if installed, remove black valve

cover strip, pull plug wire using special black plastic tool in tool kit, blow out debris

around plug using compressed air!!! repeat again after turning the spark plugs a couple

of turns, remove spark plugs using tool kit socket or 5/8 in. deep well thin wall socket,

place oil drain pan under valve cover, remove valve cover (6mm hex), remove black

rubber timing hole plug, turn lower alternator pulley clockwise with 17mm box wrench,

insert long screwdriver into plug hole while turning engine over, when it is pushed out

the maximum start looking for timing marks Z - S - OT, center OT in window, adjust

proper valves, intake = .006 in (.15mm), exhaust = .012 in (.30mm), using 10mm box,

3mm Allen, and dual feeler gauges, rotate engine 360 degrees and adjust valves on the

other side, clean valve covers, wipe oil off gasket, be certain center gasket is in place

on valve cover!!!, replace valve cover (see Stephen Karlan “Valve Adjustment”)

Spark Plugs

replace plugs every 12K miles, visually check gap for damage, lightly coat plug threads

with anti-seize, install, torque to 15 ft.lb.(20 Nm), replace plug wire, replace black valve

cover strip, replace alternator cover ( do top right bolt first!) replace valve cover

protector (short screw to the front), replace timing hole plug

Replace Air Filter

replace air filter every 12K miles, remove front seat, unsnap two clips, lift cover, remove

old filter, insert new filter seating bottom gasket carefully, install cover by pivoting up to

align front hinge tabs, snap two rear clips

1 2 3 4 5 6 7 8 9 10 ... 63 64

Keine Kommentare

BMW R1100 Spezifikationen Seite 5