BMW R1100 Spezifikationen PDF herunterladen (Seite 18)

Clutch Adjustment - Bob Gorman

A just released service bulletin revises the clutch freeplay specification to 12mm

between the knurled nuts and 7mm at the lever. This is revised from 10mm and 5mm

respectively.

It appears that improper clutch adjustment has been the cause of many shifting

problems. In order to obtain the new clearances you'll need to adjust the clutch at the

motor. You can have your dealer do it next time you have service or you can easily do it

yourself.

Equipment:

13mm deep well socket

10mm socket

socket swivel attachment

socket wrench

6" socket extension

13mm box end wrench cutoff to 2"

Procedure:

Place the extension on the wrench

place the swivel on the end of the extension

place the 13mm socket on the swivel

approach from the left side of the bike

reach in and just crack loose the 13mm locking nut at the rear of the tranny

place the 2" 13mm box end over the locknut. This will keep it from turning

remove the 13mm socket and replace it with the 10mm socket

reach in and back out the 10mm adjusting nut until you achieve spec.

give the 10mm nut another 1/2 turn

remove the 2" 13mm wrench from the locking nut

replace the 10mm socket with the 13mm socket

reach in and tighten the lock nut.

In the process the 10mm will regain that 1/2 turn you put in.

The entire adjustment takes, maybe, 2 minutes.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 63 64

Keine Kommentare

BMW R1100 Spezifikationen Seite 18