BMW E91 Bedienungsanleitung Seite 49

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 58
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 48
49
I located connector x11003 at the back – it’s a green connector also shown here (I’ve also been told it comes
in blue):
Note that the picture you should be paying attention to is in the lower left corner of this diagram. This
“window” is looking at the back of the JBE (as you are looking at it from the passenger seat), but the front side
of the JBE which ordinarily faces the firewall of the car. Basically, when you pull the JBE down, it is the top-
right connector which happens to be green. I ran the controller K-can bus wires to the back of the CCC itself
and soldered them/heat-shrinked them into the K-Can bus wiring. (The stock location for the K-Can bus
wiring junction is approx. 12” down the harness on the driver’s side of the transmission hump, below the
carpet line. You can tie-in anywhere along this leg of the bus but do your best to keep the wires “wound” like
the factory harness. Controller wiring should be as follows:
Connect Pin #1 (RT/WS – Power) from controller (x10387) to Pin #3 of connector x11003 at back of
fuse box
Connect Pin #2 (BR – Ground) from controller (x10387) to any common ground/chassis or to x13016
Connect Pin #3 (OR/GN – K-Can H) from controller (x10387) to Pin #11 of connector x13812 at CCC
Connect Pin #4 (GN – K-Can L) from controller (x10387) to Pin #9 of connector x13812 at CCC
Seitenansicht 48
1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 57 58

Kommentare zu diesen Handbüchern

Keine Kommentare