BMW E39 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Kfz-Elektronik BMW E39 herunter. Dynavin Solutions: E39 Dash Disassembly and Dynavin Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 19
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
Dynavin Solutions: E39 Dash Disassembly and
Dynavin Installation
Obligatory Disclaimer: As always, I am not responsible for anything you might do to mess up
your car, follow these instructions at your own risk!
Cars with OEM navigation will have to install a wire harness (known as the 5M Fakra
harness) to connect the plugs in the trunk to the Dynavin headunit, most of the install remains
the same but the location of the various plugs and connections are different and are not
specifically covered by this DIY.
If you have an X5 you can expect a similar experience to the one outlined in this guide.
Cars with DSP.....well....you better do your homework!
Seitenansicht 0
1 2 3 4 5 6 ... 18 19

Inhaltsverzeichnis

Seite 1 - Dynavin Installation

Dynavin Solutions: E39 Dash Disassembly and Dynavin Installation Obligatory Disclaimer: As always, I am not responsible for anything you might d

Seite 2

External bluetooth microphone (the dynavin has a built in one as well, you can experiment to find what works best for you in your car) Steering whee

Seite 3

The antenna adapter for later cars

Seite 4

The antenna adapter for earlier cars. Your cars may have plugs for both antenna adapters but you will want to use only the one below for proper radio

Seite 5

may want to install the following. Ipod to Aux In audio/video adapter cable Headphone jack to Aux In audio cable

Seite 6

USB (this is the flush panel mount one that I used in my Dynavin Info writeup but any USB extension will work. More info about my USB installation

Seite 7 - Install

I placed the GPS antenna on the metal crossmember behind the radio/under the dash top, its magnetic so it will stick right to the metal. This locati

Seite 8

Clamp down the retainer clip Plug in the steering wheel interface into the dynavin harness (if you didnt already)

Seite 9

Run your ipod cable, USB cables, Aux in cables and whatever else you are installing to wherever you would like them, popular locations are the glov

Seite 10

Once you are satisfied that everything is connected and working its time to get that thing in the dash! Now for the tricky part... you will need to

Seite 11

And thats it! All done! Pat yourself on the back, crack open your favorite beverage, and enjoy your new toy! Thanks for the purchase, I hope y

Seite 12

Start by pulling the volume knob off the factory head unit, just pull, it should come right off in your hand. Next use a 1.5mm allen wrench (I

Seite 13

IT IS NOT A SCREW! It is a “release” and turning it about a ¼ of a turn will release the MID and it will swing out...Its just like a doorknob and

Seite 14

The remaining portion of the head unit will be held in by two screws, take these out and remove the remaining part.

Seite 15

Unplug the radio, there is a large black plug with a “retainer” that has to be swung out to release the plug. Now for that little door that cover

Seite 16

pry the parts apart enough for the pin to pop out of the hole its in. Like this! Once the one side is free you can just pull the door out of the r

Seite 17

Install Lets get familiar with the plugs and connections. Here is what we are starting with, you will likely not use many of these plugs but it

Seite 18

The steering wheel control interface is the black box, it plugs into the Dynavin harness and also plugs into the IR IN plug as shown belo

Seite 19

Now lets take a look at some of the parts you will find in the box.

Kommentare zu diesen Handbüchern

Keine Kommentare