BMW X5 DVD Video System II Bedienungsanleitung Seite 9

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 12
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 8
INSTALLATION OF THE DVD DRIVE
42. Remove the cargo floor panel and the left access panel (by the CD changer area).
43. Remove the left plastic support tray by loosening three (3) 10mm screws. Put it away.
44. Route the A/V and power cables by the left side through the left hand C-pillar and around the left rear seatbelt
mechanism. Then continue routing them behind the trim panel in the trunk (above the left rear wheel well) to the left rear
component area (where the CD changer is installed).
45. If equipped, remove the CD changer and CD/DVD drive for the navigation system. Make sure you label all cables
and connectors.
46. Locate the white 12-pin connector from the wire harness center by the bottom of the left access panel (or to the left
of the black support trim removed in step 43 above).
47. Remove the white connector from the wire harness center and connect it to one of the white harness in the DVD
power harness. Connect the other harness of the DVD power harness to the wire harness center.
48. Adhere the supplied hook tape to one side of the Timing Circuit Module (part of the DVD power harness) and mount
it on the bottom of the shelf.
49. Mount the L-mounting brackets to the side of the DVD drive and secure them with 4 screws.
50. Connect the audio and video cables to the connectors on the DVD drive.
51. Mount the DVD drive at the top of the bracket using the supplied 8mm bolts. Mount the CD/DVD drive (for
navigation system) and CD changer if equipped.
52. Secure all lose wires with the supplied wire ties.
53. Reinstall the left access panel and cargo trunk cover.
54. Reinstall the C-pillar trim panel by pushing it in the vehicle side body. Insert the plastic blind rivet into the bottom of
the C-pillar trim panel and pull the locking pin (or use the rivet setter to set the rivet in place).
55. Reinstall the left rear door moulding.
56. Reinstall the grab handle.
Seitenansicht 8
1 2 3 4 5 6 7 8 9 10 11 12

Kommentare zu diesen Handbüchern

Keine Kommentare