BMW On-Board Computer Wartungshandbuch PDF herunterladen (Seite 139)

Make sure that the battery of the

donor vehicle has a voltage rating

of 12 V.

Make sure the ground is level

and firm and place the motor-

cycle on its stand.

Remove battery cover ( 139).

When jump-starting the engine,

do not disconnect the battery

from the on-board electrical

system.

Remove protective cap of the

positive terminal 1.

Use the red jumper cable to

connect the positive terminal 2

of the discharged battery to the

positive terminal of the donor

battery.

Then connect one end of the

black jump lead to the negative

terminal of the donor battery

and the other end to negative

terminal 3 of the discharged

battery.

Run the engine of the donor

vehicle during jump-starting.

Start the engine of the vehicle

with the discharged battery

in the usual way; if the en-

gine does not start, wait a few

minutes before repeating the

attempt in order to protect the

starter motor and the donor

battery.

Allow both engines to idle for a

few minutes before disconnect-

ing the jump leads.

Disconnect the jump lead from

the negative terminals first,

then disconnect the second

lead from the positive termin-

als.

Do not use proprietary

start-assist sprays or other

products to start the engine.

Installing front seat ( 75).

Battery

Maintenance instructions

Correct upkeep, recharging and

storage will prolong the life of

the battery and are essential if

warranty claims are to be con-

sidered.

Compliance with the points be-

low is important in order to max-

imise battery life:

Keep the surface of the battery

clean and dry

Do not open the battery

Do not top up with water

Be sure to read and comply

with the instructions for char-

ging the battery on the follow-

ing pages

Do not turn the battery upside

down

8

137

z

Maintenance

1 2 ... 134 135 136 137 138 139 140 141 142 143 144 ... 183 184

Kommentare zu diesen Handbüchern

Keine Kommentare