(-) Installing brackets with LED auxiliary headlights on both
sides
Remove screws (1); these screws are no longer needed as longer screws
will be installed instead.
Slip flat nuts (2) onto fairing bracket (3) (arrow).
Hold the bracket complete with LED auxiliary headlight (4) in position.
Install screws (5) and (6) and tighten until hand-tight.
Tighten screw (5) first and then tighten screw (6).
Bracket for auxiliary headlight to fairing bracket
front with front-wheel cover, M5 x 25
(-) Removing cover from multifunction switch
With the clutch lever pulled slightly, work cover (2) up off the multifunction
switch.
(-) Installing cover with switch actuator
With the clutch lever pulled slightly, lower cover with switch actuator (1)
into position on the multifunction switch.
(-) Securing cable of LED auxiliary-headlight switch
Route actuating cable (1) down parallel to wiring harness (2).
Remove the original cable ties and secure actuating cable (1) to wiring
harness (2) with cable ties (arrows) installed at the same positions as the
original ties.
BMW-Motorrad - 0450 - R 1200 GS, K25 31
Kommentare zu diesen Handbüchern